SciCan Statim 2000 Manual do Operador descarregar pdf (Página 10)

6. To select the next field, press the RUBBER AND PLASTICS cycle button.

7. To save changes and return to the regular operating mode, press the STOP button.

8. To quit without making changes, power the Statim OFF.

3.7 Language Selection

The messages displayed on the LCD can be changed to a number of different languages.

To change the current language selections, follow these steps:

1. Turn the power switch at the back of the unit OFF.

2. Press and hold the WRAPPED cycle button.

3. While depressing the WRAPPED

cycle button, turn the power switch at

the back of the unit to ON.

4. Press the UNWRAPPED cycle button to scroll to the next language selection.

5. Press the WRAPPED cycle button to scroll to the previous language.

6. When the desired language is displayed, press the STOP button to save the selection

and return to the regular operating mode.

3.8 Assigning Unit Identifier Number

1. Power the Statim OFF.

2. Press and hold the RUBBER / PLASTIC cycle button.

3. While pressing the RUBBER / PLASTIC cycle button, power the Statim ON.

4. Using the cycle buttons, select a maximum of 3 digits to be used as the unit’s identifier.

The UNWRAPPED button will increase the selected value and the WRAPPED cycle

button will decrease it. Use the RUBBER / PLASTIC to move to the next digit.

5. To save changes and return to the regular operating mode, press the STOP button.

3.9 Adjusting the Cycle Drying Time

The Statim has a preset drying time of 30 minutes. You can adjust this time between 15 to

60 minutes in increments of 1 minute.

1. Power the Statim OFF.

2. While pressing and holding the STOP cycle button, power the Statim ON.

3. Using the WRAPPED and UNWRAPPED cycle buttons scroll to AIR

DRYING and press the RUBBER / PLASTIC button.

4. Using the WRAPPED and UNWRAPPED cycle buttons, scroll to

the desired drying time and select it by pressing the RUBBER / PLASTIC

button.

3. Installation

N.A. ENGLISH

Display when scrolling through languages

STATIM 2000 S2S2R601

#323

Display when assigning unit number

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 48 49

Sem comentários

SciCan Statim 2000 Manual do Operador Página 10