SciCan Statim 2000 Manual do Operador descarregar pdf (Página 38)

7.1 Installing Paper on the Internal Printer

Use only paper approved for use with the optional internal printer on the Statim 5000.

The use of any other paper will damage the printer and will void the warranty. Thermal

paper is available from your dealer (SciCan order no. 01-101657S).

Do not operate the printer without paper. If you run out of thermal paper, or if you do not

wish to use the printer, turn it OFF.

Never pull the paper backwards through the printer.

This will damage the printer mechanism.

To install the paper into the printer, follow these steps:

1. Power the Statim 5000 ON.

2. Open the printer door

by pushing on the top half of the door.

3. Power the printer ON.

4. Unroll some paper from the thermal paper roll

and trim the corners using the

paper cutting template included with each box.

5. Move the paper roll arm

into the loading position. Place the paper roll

on the arm

so the paper strip feeds from the top of the roll and then carefully insert

it into the paper feed slot

until it stops.

If the paper does not feed from the top, the heat sensitive side of the paper will not be in

contact with the print head and the printer will not print.

6. With one hand, continue to gently feed the paper strip into the paper feed slot. With the

other hand, press the paper advance button until the paper feeds by itself.

Keep the paper straight when feeding it into the printer or it may jam. Do not force the

paper into the slot! If the paper will not feed into the slot, pre-cut the end of the roll again

and reload the paper.

7. Internal Printer (Not on all models)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 48 49

Sem comentários

SciCan Statim 2000 Manual do Operador Página 38