SciCan Statim 2000 Manual do Operador descarregar pdf (Página 43)

8. Troubleshooting

Cycle interrupted — NOT STERILE,

Cycle aborted — NOT STERILE and

CYCLE FAULT messages.

If kinked, straighten the tube. If the tube cannot be

straightened, remove it from the push-in fitting attached

to the Statim. Depress the collar on the fitting and with

the other hand pull firmly on the tube. Once the tube is

free of the fitting, cut the damaged section of tubing

away using a sharp instrument. Be sure that you leave

enough tube to reach the unit when you re-attach the

tube to the exhaust fitting. If the tube is too short to

remove a section, contact your SciCan dealer for

a replacement.

Make sure the compressor is working. To check,

remove the exhaust tube from the waste bottle.

Start the Air Drying Only Cycle, and place the free end

into a glass of water. If there is not a strong, steady

flow of bubbles, the compressor is not

functioning properly. Contact your SciCan dealer.

Record the CYCLE FAULT number. Wait a few minutes

and attempt another cycle before proceeding to the next

solution. Remove the cassette. Be careful. The metal

parts will be hot and the cassette will contain hot steam.

Inspect the cassette to ensure that the holes in the back

of the seal are perfectly aligned, and that the flexible lip

of the seal is completely free. Check the exhaust tube

for kinks or obstructions. If kinked, straighten the tube.

If the tube can not be straightened, remove it from the

push-in fitting attached to the Statim. Depress the

collar on the fitting and, with the other hand pull firmly

on the tube. Once the tube is free of the fitting, cut

the damaged section of tubing away using a sharp

instrument. Be sure that you leave enough tube to

reach the unit when you re-attach the tube to the

exhaust fitting. If the tube is too short to remove a

section, contact your SciCan dealer for a replacement.

Check that the Statim has not inadvertently been

exposed to any electrical interference.

Refer to the Installation section dealing with

Environmental Considerations. (Section 3.1)

Try running another cycle. If the problem persists,

record the cycle fault message number and contact

your dealer.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 49

Comentários a estes Manuais

Sem comentários

SciCan Statim 2000 Manual do Operador Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Recetores multimédia para automóveis SciCan Statim 2000