SciCan Statim 2000 Manual do Operador descarregar pdf (Página 40)

7.2 Removing Internal Printer Paper Jams

If paper jams in the printer and cannot be

removed by pressing the paper advance

button

, the printer must be disassembled.

Do not pull the paper backwards through the

printer and never put utensils or tools into the

paper exit slot.

When paper is jammed in the printer, follow

these steps to remove the jam:

1. Power the Statim 5000 OFF and unplug the

unit.

2. Using scissors, cut the paper between the

roll and the paper feed slot

3. Remove the paper roll

from the paper

roll arm

and leave the arm in the

loading position.

4. Using a #1 Phillips screwdriver, remove the

three screws

from the printer cover

and

remove the cover.

5. Note the orientation of the exposed printed

wiring board and the paper roll arm

assembled on the printer door

6. Gently lift the printed wiring board upwards and away from the printer door. Exercise

care while handling the board. The printer is integral to the wiring board. Do not

place strain on the connections of the ribbon cable soldered to the board. Do not

remove the connector of the flexible cable from the connector header on the board.

The paper drive mechanism on the underside of the wiring board is now exposed.

7. Using a pair of tweezers or fine needle-nosed pliers, carefully remove the paper

from the mechanism.

When the paper is removed, reassemble the printer:

1. Carefully snap the paper roll holder, in the loading position, back into the clips on the

printer door

7. Internal Printer (Not on all models)

Figure 16

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 48 49

Sem comentários

SciCan Statim 2000 Manual do Operador Página 40