SciCan Statim 2000 Manual do Operador descarregar pdf (Página 35)

6. The Communication Port (Not on all models)

Setting the Serial Port Bitrate to 9600

1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll

to the Serial Port Bitrate menu and select it using the RUBBER AND PLASTIC

button.

2. From the Serial Port Bitrate menu, use the UNWRAPPED and WRAPPED buttons to

scroll down to 9600 and press the RUBBER AND PLASTIC button to select and

return to the User Setup menu.

Setting the Printer user Character; (example: 134°C)

1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll

to the Printer user ° char menu and select it using the RUBBER AND PLASTIC

button.

2. From the Printer user ° char menu, using the UNWRAPPED button to increase the

displayed value by one, and the WRAPPED button to increase that value by ten,

enter the value 32 [0x20] and press the RUBBER AND PLASTIC button to accept

and return to the User Setup menu.

Save and Exit

A Save and Exit must be performed after the above settings are completed. If this is not

done, the information will revert to its prior settings.

1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll

to Save and Exit.

2. Select it by pressing the RUBBER AND PLASTIC button.

The LCD will display time and date

information and a sequence of

messages:

Save and Exit

HH:MM DD/MM/YYYY

“MSD NOT DETECTED”/”INSERT

MSD/FLASH”/”SELECT A CYCLE”

Serial Port Bitrate

9600

Printer user ° char

32 [0x20]

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 48 49

Sem comentários

SciCan Statim 2000 Manual do Operador Página 35